All posts are those of the individual authors and the owner of this site does not endorse them. Content should be considered opinion and not fact until verified independently.

February 09, 2003 09:08AM
The springs are on USFS land so they are free. There are several pools at different temperatures that range from about 90 to 109 degrees depending how close to the source they are.

From Green valley Lake you could come in on the 173 if you don't mind dirt roads. The Bradford ridge trail starts at the little white wooden bridge that is five miles before the pavement. The USFS requires a Forest Adventure pass to park here. This trail takes about an hour ten down, and an hour and a half up and is quite steep when it decends down to Deep Creek.

If you prefer an easier trail you should take the 138 to the 173, and then take the road down to Hesperia, continue east to Bear Valley Road. Make a right on Bear Valley and then another right at Central (the first stop sign). After you go over a small steep hill make a left on Ocotillo, and then a right on Bowen Ranch Road, stay on the right at all forks till you see the welcome sign to Bowen Ranch. Mike charges $4 per person to park on his land. From there the trail is about a forty minute hike down, fifty to an hour up.

Hope you have a good time. Please remember no glass, campfires or overnighting is allowed at the springs. Come back and let us know you it went.
SubjectAuthorViewsPosted

Never been to Deep creek hot springs.

Kyle 1087February 09, 2003 03:12AM

Re: Never been to Deep creek hot springs.

Ron 665February 09, 2003 09:08AM

Re: Never been to Deep creek hot springs.

Wizard 678February 09, 2003 10:47AM

Re: Never been to Deep creek hot springs.

Rick 732February 09, 2003 11:52AM

Re: Never been to Deep creek hot springs.

george 678February 19, 2003 03:46PM

Re: Never been to Deep creek hot springs.

Celtfire 1076February 21, 2003 10:28PM

Re: Never been to Deep creek hot springs.

Wizard 637February 09, 2003 12:29PM

Re: Never been to Deep creek hot springs.

Wizard 730February 19, 2003 08:03PM



Sorry, only registered users may post in this forum.

Click here to login