Welcome! Log In Create A New Profile Recent Messages

Deep Creek Hot Springs

The Moon is Waxing Gibbous (90% of Full)


Advanced

Re: Dirt road to Freedom Trail and back

All posts are those of the individual authors and the owner of this site does not endorse them. Content should be considered opinion and not fact until verified independently.

November 10, 2013 11:55AM
Paul, I believe those distances you quoted are accurate although I did not measure. However, you cannot go wrong. Just remember left, left, left on way in and right, right, right on way out, ignoring all the other intersecting roads. Anything just barely an inch higher than my car will be just fine without any off-road experience. I did not scrape my bottom at all although in some spots had to be very, very careful in navigating the holes and dips.

If you stop by video at about 4:30, I purposely zoomed onto my GPS about a mile from the Bowen Ranch intersection coming back and as you can see, the thing doesn't even know the road exists.

I was thinking from a security perspective, one possible solution is picking up a small surveillance cam. I recall Rick posted a link to one in an older thread. Or bring a car cover for a newer vehicle. Or pay jobe to watch it for you while you soak :-)
SubjectAuthorViewsPosted

Dirt road to Freedom Trail and back

mohave1960November 10, 2013 03:33AM

Re: Dirt road to Freedom Trail and back

Paul P.922November 10, 2013 09:00AM

Re: Dirt road to Freedom Trail and back

jobe890November 10, 2013 08:41PM

Re: Dirt road to Freedom Trail and back

mohave992November 10, 2013 11:55AM

Re: Dirt road to Freedom Trail and back

mohave1000November 10, 2013 01:42PM

Re: Dirt road to Freedom Trail and back

Paul P.759November 10, 2013 04:45PM

Re: Dirt road to Freedom Trail and back

mohave763November 10, 2013 05:09PM

Re: Dirt road to Freedom Trail and back

mohave870November 17, 2013 12:34AM

Re: Dirt road to Freedom Trail and back

jobe774November 17, 2013 06:38AM

Re: Dirt road to Freedom Trail and back

Paul P.1738November 17, 2013 08:34AM



Sorry, only registered users may post in this forum.

Click here to login